Arduino Code Needed for interfacing DAC and LCD on SPI including Rotory Encoder
$30-250 AUD
Ολοκληρώθηκε
Αναρτήθηκε περίπου 10 χρόνια πριν
$30-250 AUD
Πληρωμή κατά την παράδοση
Project is to write a sketch for the arduino IDE to interface an ATMega328 with a DAC (MCP4822 12 Bit) and Phillips PCD8544 LCD (Nokia 5510 LCD) over SPI
DAC Requirements
Rotory Encoder will be used as an input to send data to DAC
Pushbutton(1) will switch between the 2 Outputs
Pushbutton(2) will Step Up output by 10% increments then when 100% is reached will step back down
Pushbutton(3) will ramp from 0 - 100% in 30s then stop, button is pressed again will ramp back down
Rotory encoder will override Pushbuttons 2+3 when rotated
LCD Requirements
To show which channel is selected on the dac
Channel 1 will display Voltage
Then underneath show a reading from one off the analog pins which will scale a reading from 0-2.048v to 0- 10v
Chanell 2 will display Current
Then underneath show a reading from one off the analog pins which will scale a reading from 0-5v to display 4-20ma
Code shall be written in the most effective and efficient manner must include Code Notes
Hello,
I have a long experience in Hardware and Software product development. I am also have done several Arduino projects (some of them on freelancer.com).
I have an Arduino board and I can use it to compile and test some of the functions like voltage measurements etc before delivering.
I have also included the price (and time to buy) of a PCD8544 that I can buy and test the software for delivery.
Please let me know..
Thanks
Vinod
$222 AUD σε 15 ημέρες
5,0 (9 αξιολογήσεις)
5,8
5,8
11 freelancers δίνουν μια μέση προσφορά $260 AUD για αυτή τη δουλειά
I am not familiar with Atmel chips as I didnt like to use anyway. I am a microchip fan so all my 8 bit coding is limited to PIC micros. It seems some kind of power supply related design. Rotary needs velocity control so that when you rotate the encoder faster then it will increase the values faster. MCP4822 is a nice DAC which I use mostly when 12 bit is required. Its just a formal bid because I cant work with arduino even if its too simple to code. So in case if you have plan to use microchip PIC device then please do get in touch. I used such kind of setup in one of my power supply project which had USB connectivity and MCU was PIC18F4550 and true USB2.0 port. Thank you very much for your time. Regards.
Hello Sir,
We have resources both hardware and software to build the prototype of your project and present it to you. We can complete this. Please contact if you are interested. Thank you,
Hi,
I am professional embedded developer and have experience in C coding.
I have around 2 years of experience in PIC, arduino coding.
Something similar I have done in various projects. I can take up this project.
Let me know if you are OK with project time.
Looking forward to your response.
yup i can make this code within notime as i have worked on it and m very comfortable on arduino software , you can call me for any application and its not tough to make that code , and when u need the code and i will provide you the same with in no time.