PIC18 jump from bootloader to aplication

€8-30 EUR

Κλειστή

Αναρτήθηκε

περίπου 5 χρόνια πριν

€8-30 EUR

Πληρωμή κατά την παράδοση

I have a little bootloader that flash a new firmware into the top memory, when it finish i make Reset() (LINE 197) and aplication runs fine , the problem is when I turn off the circuit, it start again from bootloader I make a eeprom variable set to 1 if flash was sucessfuly, so then if eeprom == 1 I perform a reset() (LINE 79) to force to start aplication but doesn't work PIC18F26K22 made in MPLAB X 4.20, i don't accept another version

C Programming

Electrical Engineering

Electronics

Firmware

Microcontroller

Ταυτότητα εργασίας: 19260715

Σχετικά με την εργασία

4 προτάσεις

Απομακρυσμένη Εργασία

Ενεργός/ή 5 χρόνια πριν

Ψάχνεις τρόπο για να κερδίσεις μερικά χρήματα;

Διεύθυνση Email

Πλεονεκτήματα πλειοδοσίας στο Freelancer

Καθόρισε τον προϋπολογισμό σου και το χρονοδιάγραμμα

Πληρώσου για τη δουλειά σου

Περίγραψε την πρόταση σου

Η εγγραφή και η πλειοδοσία σε εργασίες είναι δωρεάν

4 freelancers δίνουν μια μέση προσφορά €34 EUR για αυτή τη δουλειά

@Hafeez143

Hi, I found that in your code at line 198 you are calling GotoAppUser(); after calling Reset(); but this is not done at line 79. Regards, Hafeez

€50 EUR σε 1 ημέρα

4,9

(13 αξιολογήσεις)

5,9

@gsa5b06f37877085

Hello, I am an electromechanical and electronic technician, and I only have the thesis to be an electronic engineer. I work in an electrical testing laboratory, under international standards, im work here for more than a year ago. I have experience in electronics design. If you want to know something else, do not hesitate to contact me I think it could be of great help for your project. I am already at your disposal. regards

€30 EUR σε 10 ημέρες

5,0

(2 αξιολογήσεις)

2,3

@jayanthd2k12

I have 17 years experience with electronics and 8 years of experience in embedded electronics. I have worked with 8051, PIC, AVR, PIC24, dsPIC, PIC32, STM32, Tiva, Stellaris, LPC, MSP430, FT90x, Arduino, ChipKit, RaspBerry Pi controllers. I have all the necessary tools (software, hardware, and test equipment) like Keil, mikroC, mikroBasic, mikroPascal, CodeVisionAVR and much other software. I have many development boards and modules. I have a lot of test equipment to test and debug the codes like Oscilloscope, Logic Analyzer, etc,... I can provide you a working professional code within 1 hour. You can contact me at jayanthd2k12(at)gmail(dot)com In the above replace (at) with @ and (dot) with .

€22 EUR σε 1 ημέρα