A 5*30cm PCB row of CL6807s

This is easy task to handle, and i can support you on the prototypes too. May you send a sketch of the new layout you want to have so the redesign can be done more precisely. Thanks!

Hello. I can do this. .

A proposal has not yet been provided

Hi I am interested to this project. I am familiar with electronics, PIC microcontroller as well as PCB design by eagle. Thanks.

Hi, I am an Electrical Engineer practicing for last 10 years in an R&D Organization. I have designed a number of products ranging from RF & Microwave circuits to digital circuits. i have experience in designing filters, couplers, LNAs, Amplifiers, antennas, sweep generators, function generators, VCOs, NCO and many more in the frequency range of DC to 2 GHz. i use ADS, HFSS, OrCAD, Eagle PCB and Altium for the design and development of the above mentioned products. I have designed circuits for Filters, Couplers, LNA, Amplifiers, Antennas, Bluetooth, WiFi, GSM, GPS, Sweep Generators, Function Generators, VCOs, NCOs, DDS, 555 timers, AM Modulators, Microcontrollers, EEPROM, Flash, Accelerometers, USB, RTC, Strain Guages, Opto-couplers etc. My area of expertise include also PCB Schematic and Layout Design, Antenna Design, PCB Prototyping and testing, Programming using LabWindows, LabVIEW and MATLAB, etc. Looking forward to discuss in detail. Regards

I have 4 years experience in embedded systems. I have designed many types of pcb in eagle Cadsoftware . I can do your job within a time limit with your satisfaction.

Could you give a little more information about what you want? As far as I have understood, you want multiple drivers in one board but separated with some "V-cuts" or "routing" so they can be snapped off of the other drivers on the PCB? And, if the board is not snapped off, it should still be connected to the other drivers and share the inputs?

Hi We can do this pcb design for you. You will have to tell us, if possible, also the preferred LED Part Nr that the LED driver will supply, as we have to set the current sense resistor accordingly their specs. Best regards Sotiris Papadimitriou

Hello! I would like to help you with your project. Please, tell me additional details or requirements to this task and i will create the device. I can do this task in a short time

We realize your project with the best Altium Designer software. We adapt to customer requirements .

I am working at software house. I am professional in it.

Soy muy responsable y tengo mucha experiencia en diseño de PCB. También trabajo con este tipo de driver, ya que diseño luminarias LED.

That's relatively easy for me, maybe we can have some cooperation.

Hi Dear! I have many experience circuit design. I could enough understand your proposal. You can see from my portfolio. I will satisfy your requirement perfectly in short times. Your project success is my happiness. I will do my best for you. I am looking for your reply. Warm Regards. Luo.