Create very simple PCB layout from schematic and provide electronic file (GERBER compatible)

Design of a very simple printed circuit board of 2cm x 2cm with the following components: 1N5819 Schottky Diode 10uF/16V Electrolytic Cap 470uF/10V Electrolytic Cap LM2940S-5.0 5V Regulator SMD IC All of the connector pads should be along the bottom side of the board in the order shown on the schematic. The 3 OSD pads will have pins attached to it for connecting with a jumper style connector and therefore must be the correct distance apart for this to work. The regulator should be at the top end of the board for heat reasons. ## Deliverables * * *This broadcast message was sent to all bidders on Monday Oct 6, 2008 12:35:32 PM: The pins for the OSD will be like this: [login to view URL] Please leave the correct spacing between pads for these pins to be added. The other pads at the bottom of the board should be 2mm or so higher than the OSD pads (where there will be pins) so that board and pads can be protected with heatshrink and the pins can stick out below.