DCDC Converter Analysis and Design

Analysis and Report of Converter Schematic with Proffessional Report I need to design a voltage controller and current and converter in PSim for a dc-dc fully isolated converter and a simple boost converter where the controller parameters are checked , analyzed , tuned and chosen. Matlab, Matlab toolboxes and or simulink should be used for this process. There should be closed loop voltage control design (where necessary, with PI blocks, filters, comparators, voltage sensors, voltmeters, ammeters etc.) with reasons for block use and analysis on Control design. The circuit should simulate correctly with minimal ripple and smooth outputs. For the control design, where necessary, please include a Vreferecnce, error summer, pi block, and the gating signal should be appropriate with the reason for choice. I require a transfer function for the controller and converter with variable descriptions and component relation to variables in transfer function. I will give the spec on acceptance - they are kV converters. Design the converters for OPTIMUM efficiency and show calculation overall efficiency with Pin and Pout Values; also design for lowest losses with reason for use of components and how they increase efficiency of reduce losses. I'm trying to do an investigation looking at installed power in the semiconductors, size of passive components, evaluation of losses in semiconductors, losses in magnetic components and overall efficiency (so I need all these results with calculations, equations and reasons for use). The magnetic losses of the converter should be calculated with equations. Require files to be saved in PSIM 9.0. If you require reference papers for assistance, I can attach them as well. and a start as soon as possible. Figures should be copied from clip board as a bitmap file and analysed and explained. The report template will show and example. Stresses, losses, installed power etc. analyzeD. Need all files Psim, word and MATLAB. I have completed the circuits and need to check for optimum efficiency and output and operation. I require the equations to be laid out in the format shown in the template. PSIM and Matlab to be used. Will send attached file on acceptance. No time wasters please!