Design me a Product

Ολοκληρωμένο Αναρτήθηκε Πριν 7 χρόνια Πληρώθηκε κατά την παράδοση
Ολοκληρωμένο Πληρώθηκε κατά την παράδοση

I'm looking for a PCB circuit design with below given specification:

1. Input source is 12v. Provided by using a 220v AC to 12v DC external converter circuit (input can be taken as direct source without displaying converter module in circuit but voltage spikes possible in 220v raw input source)

2. Perform 12v to [url removed, login to view] precise conversion to power ESP8266 with circuit protection. ESP should be protected from any known threats (may be optoisolated or other component based protection to be used).

3. Output of ESP as a [url removed, login to view] control signal is used in 12v based relay to power an output which goes to a 12v device with 3 Amp, 12W consumption, 4 Ohm electrical resistence. This output device will not be a part of this circuit design. Protection may be provided to the microcontroller with optoisolated or freewheeling diode or any other appropriate means possible.

4. Heat consideration shall be taken as the circuit would be powered on 24x7x365, thus components should not be operating at their maximum limits. Temperature protection, over-current protection and short circuit protection shall be done where required.

5. Other considerations: Circuit isolation, Voltage spike protection

Will need a very short explanation of components used, Gerber and other source files so that future changes can be done. Do let me know the software you'll be using for designing & simulation and the type of circuit protection that you'll use. The components & design should be such that its high quality with lowest possible cost.

The budget can go a little higher (upto 40-50$) for the right bid if circuit protection is of commercial quality. Please do mention the type of protection to be used if you would like to bid higher than the amount mentioned.

Σχεδιασμός Κυκλωμάτων Ηλεκτρονικά Μηχανολογία PCB Layout Σχεδιασμός Προϊόντων

Ταυτότητα Εργασίας: #12644041

Σχετικά με την εργασία

3 προτάσεις Απομακρυσμένη εργασία Ενεργό Πριν 7 χρόνια

Ανατέθηκε στον:

SEELaboratory

Optocouple, supressor, three-terminal capacitor, varistor, inductor, RC-filter may be used for surge protections. I suggest to use digikey for component buying. I can do PCB design in Altium Designer or in Cadence Orc Περισσότερα

₹3000 INR σε 7 μέρες
(3 Αξιολογήσεις)
2.3

3 freelancers κάνουν προσφορές κατά μέσο όρο ₹2592 για αυτή τη δουλειά

manvickpaliwal

Hello, I have worked on various esp8266 projects and the one you want for your application. i can provide the solution right away Warm regards, manvick

₹2000 INR σε 1 μέρα
(0 Αξιολογήσεις)
0.0